HongKong Baisite Bearing Co., Ltd
All News
- New rolling joint bearings and bearing selection
- The joint bearing is a plain bearing and is mainly composed of an outer spherical inner ring and an inner spherical outer ring. Generally used for lower speed swinging motion, tilting motion and rotary motion. Compared with rolling bearings, it is simple...
- Installation and maintenance of oil pump sliding bearings
- First, the installation of sliding bearings Sliding bearings are generally used under conditions of low speed and heavy load. The following are the following elements for sliding bearing installation: 1. The sliding bearing is installed...
- Discussion on bearing selection
- 1 Introduction With the progress and development of society, mechanization has been widely used in production and life. As an indispensable part of the machine, the range of use of the bearing will become wider and wider, as the bearing is used...
- How to choose INA rolling bearing configuration
- Analysis of the selection method of INA rolling bearing configuration. Usually, the shaft is supported radially and axially by two INA bearings, and the rolling bearing on one side is called a fixed end bearing, which bears both radial and axial loads,...
- Thrust bearing support
- Thrust bearings are mainly divided into three types: rigid strut type, hydraulic strut type and balance block strut type according to the type of strut. In addition, there are elastic pads, springs, pistons, elastic disc posts and the like. details as...
- Fault diagnosis of mud pump bearings
- The mud pump is an important equipment in the drilling engineering. Its function is to input the high pressure mud used to carry the cuttings during drilling. During the drilling process, it is necessary to ensure that the high-pressure mud is pumped...
- Rolling bearing assembly method
- When assembling the bearing, the most basic requirement is to make the applied axial force directly on the end face of the ferrule of the mounted bearing (when mounted on the shaft, the applied axial force should directly act on the inner ring, When the...